Adding cameras to a Heigh10+, Horizon10, or Horizon12 radio

To add a camera(s) to a Heigh10+, Horizon10, or Horizon12, follow these steps.

1. Connect the camera(s) power and ground wires to the kit's power and ground wires labeled Aftermarket Camera Power. The connectors used on the kit are bullet connectors.
2. Connect the yellow RCA jack from the camera(s) to the appropriate camera input on the radio.
   • Reverse Cam In: Backup camera. (*)
   • Cam 2 In: Left side blindspot camera.
   • Cam 3 In: Right side blind-spot camera.
   • Cam 4 In: Front camera.
3. Navigate to the radio's camera settings and enable the camera(s): Settings / Camera / Camera Setup.
   • Select the button labeled None, then select the appropriate camera label.
   • Enable the trigger.

   • If a front camera is selected, exit the menu, then re-enter to ensure Switch to Front Camera after reverse is selected if you prefer the camera to be shown after you shift from reverse.

     Note: The side cameras have a Low Speed Override feature, which disables the cameras under 3mph to allow the radio to be viewed instead. If this option is not preferred, disable it.

4. Inspect the cameras for functionality. Please note that you must drive over 3mph to inspect the blind spot cameras if the Low Speed Override feature is enabled.

Note: The aftremarket cameras can be viewed while driving if manually selected. This is especially useful for a reverse camera to view a trailer, or the blind-spot camera on the right side to view vehicles in your blind spot. Ensure this feature is legal in your area.

(*) Do not use this input in the Gladiator or Wrangler.