Matthew Calderon

When installing these kits, the dash bezel sometimes won't snap into place without excessive force. Removing two tabs on the back of the dash bezel, as shown below, makes installation easier.Applic...

This tutorial is for wiring and configuration of the Stinger EM-JP-CAM, HDCAM10U, HDCAMJW, PHD220, and PHD5N1 cameras. Before power is applied to the camera, the jumper loops must be configured.Blu...

The gain dial on the Stinger amplifier must be level matched to the source it is connected to. For this tutorial we will use the Stinger MT-1000.1 amplifier which has an input sensitivity gain from...

The following legacy firmware is only for the Heigh10 and should only be used if instructed to do so by Stinger Technical Support. These firmware files will only work with the Heigh10 “non-X” versi...

If the amplifier is not working or going into protection, follow these steps to diagnose the problem. Is the power light for the amp on? Check all fuses on the circuit. If the fuses are good, check...

If the volume knob has never worked, or worked but quit shortly after installation, follow these steps to correct the problem.Start the vehicle.On the radio, navigate to Settings / Load Defaults.Se...

If the kit is not working properly or the factory camera quits working, try these steps to fix the issue.Open the hood and locate the fuse box next to the battery. Remove the radio fuse for 5 secon...

To add a camera(s) to a Heigh10+, Horizon10, or Horizon12, follow these steps.Connect the power and ground from the camera(s) to the kit's power and ground wires labeled Aftermarket Camera Power. T...

To add a camera(s) to a Heigh10+, Horizon10, or Horizon12, follow these steps.Connect the power and ground from the camera(s) to the kit's power and ground wires labeled Aftermarket Camera Power. T...

If you have both issues, the radio and PAC data interface connectors might be swapped. On the PAC interface, find the Radio Harness connector, labeled at the bottom. It should have no RCA jacks. If...