Matthew Calderon

This legacy firmware is for Heigh10 radios only and should be used only when directed by Stinger Technical Support. It is compatible only with Heigh10 “non-X” models. The version of the Stinger rad...

If the amplifier is not working or going into protection, follow these steps to diagnose the problem. Troubleshooting StepsIs the power light for the amp on? Check all fuses on the circuit. If the ...

If the kit is not working properly or the factory camera stops working, try these steps to fix the issue. Open the hood and locate the fuse box next to the battery. Remove the radio fuse for 5 seco...

To add a camera(s) to a Heigh10+, Horizon10, or Horizon12, follow these steps. InstructionsConnect the power and ground from the camera(s) to the kit's power and ground wires labeled Aftermarket Ca...

To add a camera(s) to a Heigh10+, Horizon10, or Horizon12, follow these steps. InstructionsConnect the power and ground from the camera(s) to the kit's power and ground wires labeled Aftermarket Ca...

If both issues occur, the radio and PAC module connectors might be swapped.Applicable part numbers: RB10RUN10, RB10TAC16B, RB10TUN14, STH10HIGH18 On the PAC module, locate the Radio Harness connect...

If your contacts didn't import with Android Auto, it may be due to missing permissions or a setup glitch. To import contacts, follow these steps.Delete the phone from the radio.Delete the radio fro...

To pair your Stinger radio to your phone, follow these steps.Navigate to the Bluetooth settings on the mobile device.Locate the Stinger radio in the Bluetooth list and then select it to pair.When t...

If the dashcam reboots, follow these steps to correct the issue. Installation stepsUnplug all dashcam connections.Disconnect, then firmly reconnect the rear camera, ensuring it's fully plugged in.R...

In Bose-equipped vehicles, all audio components are connected in a loop. If an audio component is missing, you will not have sound. For this reason, the kit provides jumpers to remove unnecessary a...