Matthew Calderon

This article provides current and legacy firmware for the HORIZON12 radio, including revision history. Note: Watch the video tutorial to guide you through the firmware update process. Befor...

If the kit is not working properly or the factory camera stops working, try these steps to fix the issue. Open the hood and locate the fuse box next to the battery. Remove the radio fuse for 5 seco...

The SE-P14 and SE-P24 navigation cards are designed for use with the Stinger Heigh10, Heigh10+, Horizon10, and Horizon12 radios. Please follow the steps below to update the cards.Update Procedure ...

This tutorial explains how to add a “highs” amp to a Stinger integrated radio kit. The vehicle must be non-amplified. Installation InstructionsConnect the speaker wiresLocate the speaker connector ...

This tutorial explains how to add a “highs” amp to a Stinger integrated radio kit. The vehicle must be non-amplified. Installation InstructionsConnect the speaker wiresLocate the speaker connector ...

This tutorial is for wiring and configuration of the Stinger EM-JP-CAM, HDCAM10U, HDCAMJW, PHD220, and PHD5N1 cameras. Before power is applied to the camera, the jumper loops must be configured.Blu...

The Stinger amplifier's gain dial should be matched to the source level. This tutorial uses the Stinger MT-1000.1, with input sensitivity from 0.2V (min) to 6V (max). Know the source voltageThe RCA...

This legacy firmware is for Heigh10 radios only and should be used only when directed by Stinger Technical Support. It is compatible only with Heigh10 “non-X” models. The version of the Stinger rad...

If the amplifier is not working or going into protection, follow these steps to diagnose the problem. Troubleshooting StepsIs the power light for the amp on? Check all fuses on the circuit. If the ...

If the kit is not working properly or the factory camera stops working, try these steps to fix the issue. Open the hood and locate the fuse box next to the battery. Remove the radio fuse for 5 seco...